Description
4 mm E600 High Density EVA Foam – Hardness 60-65° Shore C
This 4mm EVA foam sheet (5/32″) is a closed-cell EVA in our E600 high density grade, at 60-65° Shore C. It is firm enough to hold a shape under load and thin enough to cut cleanly, which suits insoles, linings and layered builds.
EVA foam blends Ethylene Vinyl Acetate with copolymers and cross-links them chemically. As a result, the sheet has a fine, uniform closed-cell structure. It absorbs shock, floats, keeps out water, and resists UV and cracking.
Every figure on this page was measured in our Pacoima shop rather than copied from a mill sheet: we weighed a full sheet and checked its thickness and hardness with a caliper and durometer. That makes this 4mm EVA foam sheet a known quantity for insoles, footbed layers and laminating up to thicker blanks.
-
- Pink
Why Choose This 4mm EVA Foam Sheet
Because we measure the density and hardness ourselves, you know exactly what you are cutting before you order. At 60-65° Shore C it is firmer than our E500 sheets and softer than our E700, so it holds its shape without feeling hard.
For example, shoemakers use it as an insole or footbed layer, and cosplayers use it for armor details and prop parts where a thin, firm sheet keeps crisp edges. The large 80 x 39 in sheet also lets you cut long pieces in one go.
Cutting, Gluing and Heat Forming
First, mark your pattern and cut it with a sharp utility knife, a clicker die or a band knife. Because a 4mm EVA foam sheet is thin, a fresh blade gives a clean edge in a single pass.
Next, bond it with contact cement or a hot-melt adhesive that grips EVA. For the best hold, rough the surface lightly first.
Finally, the sheet can be heat molded for craft and cosplay shapes. Warm it evenly with a heat gun until it becomes soft and flexible, press it over your form, and hold it in place until it cools and keeps its new shape.
Best Uses for a 4mm EVA Foam Sheet
- Footwear insoles and footbed layers
- Cosplay armor and prop details
- Craft builds and models
- Sports equipment and padding
- Packaging and protective inserts
Material Data for EVA :
- Material: EVA (Ethylene Vinyl Acetate), closed cell, high density
- Grade: E600
- Density: 190 kg/m³ (nominal, 0.190 g/cm³), measured in house
- Hardness: 60-65° Shore C (ASTM D2240 durometer), measured in house
- Thickness: 4 mm (5/32″) +/- 0.5 mm
- Sheet Size: 80″ x 39″ Due to manufacturing and cutting tolerances, sheet length and width may vary by +/- 1/2″
- Color: Pink
- Origin: CN
More EVA Foam:
Browse the rest of our EVA grades and thicknesses.
